2GB 240-Pin DDR3 1Rx16 256Mx64Bit 1600MHz DDR3 Desktop PC Memory
Desktop PC 2GB DDR3 1600MHz RAM Memory Module Chip


Features:	
This document describes ValueRAM's 256M x 64-bit (2GB) DDR3-1600 CL11 SDRAM (Synchronous DRAM) 1Rx16, memory module, based on four 256M x 16-bit FBGA compo- nents. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 240-pin DIMM uses gold contact fingers.
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
800MHz fCK for 1600Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 11, 10, 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address ¡°000¡± only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ¡À 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85¡æ, 3.9us at 85¡æ < TCASE < 95¡æ
Asynchronous Reset
PCB : Height 1.180 inch30mm, single sided component


Package Contents:	
1 x DDR3 2GB RAM Memory for Desktop PC